|
Footnote refers to a specific part or application
Footnote #26
Due to the confusing W2 cylinder head part/casting number variations,
use the following measurements to determine which header will fit your
application
...see
dimension illustration
If the
center bolt
hole pattern spread measures 3-15/16” from the center of the left bolt
hole to the center of the right bolt hole;
you must use
TTi340W2
Header.
If the center bolt hole pattern spread measures
4-3/4” from the center of the left bolt hole to the center of the right
bolt hole; you must use
TTi340W2-178 Header.
Dual Bolt Pattern Heads:
Either header
may be used.
|
